Design and Implementation of Protection Relay 3 Phase Induction Motor

kukuh widarsono

Abstract

Damage to the electrical components will inevitably occur, it could be caused by several factors that influence it starting from inside and outside the system. 3 phase induction motor is the most commonly used in the industry, but often also has problems such as over current and over heat on the motor. The disturbance if left unchecked can cause fatal damage to the motor. therefore, a relay safety system has been made which utilizes a microcontroller controller to protect the 3 phase induction motors. This safety relay is designed differently than conventional safety relays used by industry in general, this safety relay is designed based on the microcontroller control and is accompanied by setting and resset facilities respectively to display on the LCD via Push Botton buttons. As such, 3 phase induction motors are protected from severe damage caused by interference with the mesh source. It is expected that by making this safety relay can reduce the value of damage to the 3 phase induction motor.

Full Text:

PDF

References

Aji, Zaenal Panutup “Teknik Pengukuran Temperature Belitan Motor Induksi Menggunakan Metode Resistansi”, Balai Riset dan Standarisasi Industri Surabaya, 2014.

Wahjono Endro “Rancang Bangun Relay Pengaman untuk Mengatasi Gangguan Motor Induksi 3 Phase”, Jurusan Teknik Elektro Industri, PENS, 2014.

Tukananto Andri “Rancang Bangun Sistem Proteksi Arus Lebih Motor 3 Fasa Dengan Timer Start dan Trip”, Jurusan Teknik Elektro Industri, Fakultas Teknik Universitas Tanjungpura, 2015.

Sholeh Moh. “Rancang Bangun Sistem Kontrol dan Proteksi Motor Listrik Terhadap Panas (Overheating) serta Peringatan Dini terhadap Gangguan Tegangan dan Arus Berbasis AtMega 328”, Jurusan Teknik Elektro, Universitas Islam Lamongan, 2018.

Standar NEMA (The National Elektrical Manufacture Association) tentang Insulation Class suatu electro motor.

Spesifikasi Three-phase Inductioan Motor with Slip-Ring Rotor

Azizi, Alvian Kurnia “Rancang Bangun Modul Praktikum Buck Boost Converter Menggunakan Kontroller PID Untuk D3 Teknik Listrik Industri” Politeknik Negeri Madura, 2016.

Data Sheet salah satu Produsen Thermistor

MURATA PartNo. NXFT15XH103).

Standar Nasional Indonesia (SNI) IEC 60335-1 : 2009, Badan Standarisasi Nasional, Jakarta-Indonesia, 2009.

Y. Yorozu, M. Hirano, K. Oka, and Y. Tagawa, “Electron spectroscopy studies on magneto-optical media and plastic substrate interface,” IEEE Transl. J. Magn. Japan, vol. 2, pp. 740–741, August 1987 [Digests 9th Annual Conf. Magnetics Japan, p. 301, 1982].

M. Young, The Technical Writer’s Handbook. Mill Valley, CA: University Science, 1989.

Refbacks

  • There are currently no refbacks.